Lab Manager | Run Your Lab Like a Business

Lab Health and Safety

Special Hazards: NFPA Hazard Diamond

Experienced laboratory managers know that there are four basic categories of chemicals: toxic, corrosive, flammable and reactive.

Vince McLeod, CIH

Vince McLeod is an American Board of Industrial Hygiene-certified industrial hygienist and the senior industrial hygienist with Ascend Environmental + Health Hygiene LLC in Winter Garden, Florida. He has more...

ViewFull Profile.
Learn about ourEditorial Policies.

Experienced laboratory managers know that there are four basic categories of chemicals: toxic, corrosive, flammable and reactive. However, in our chemical world there are many additional categories and subsets of these main four. We should also keep in mind that many chemicals exhibit a combination of properties and would fall into more than a single class or category. These four properties are the foundation of the NFPA hazard diamond.

At the bottom of the diamond is the white section. This section is used to denote special hazards. NFPA 704, Standard System for the Identification of the Hazards of Materials for Emergency Response,1 mentions only two approved symbols:

This denotes an oxidizer, a chemical that can greatly increase the rate of combustion or fire.

This means the substance is incompatible with water. It indicates a potential hazard with the use of water to fight a fire involving this material.

Some organizations and manufacturers use additional symbols to indicate hazards associated with the substance. One example is the Hazardous Materials Emergency Response Guidebook;2 a few of these are presented above.

This indicates that the material is an acid, a corrosive material that has a pH lower than 7.0.

This denotes an alkaline material, also called a base. These caustic materials have a pH greater than 7.0.

This denotes a material that is corrosive (it could be either an acid or a base).

This is another symbol used for corrosive.

The skull and crossbones are used to denote a poison or highly toxic material. See also: CHIP danger symbols.

The international symbol for radioactivity is used to denote radioactive hazards; radioactive materials are extremely hazardous when inhaled.

This indicates an explosive material. This symbol is somewhat redundant because explosives are easily recognized by their Instability Rating.

Vince McLeod is an American Board of Industrial Hygiene– certified industrial hygienist and the senior industrial hygienist in the University of Florida’s Environmental Health and Safety Division. He has 22 years of occupational health and safety experience at the University of Florida, and he specializes in conducting exposure assessments and health-hazard evaluations for the university’s 2,200-plus research laboratories.

References

  1. Standard System for the Identification of the Hazards of Materials for Emergency Response, National Fire Protection Association, Publication 704. http:// www.nfpa.org/aboutthecodes/AboutTheCodes. asp?DocNum=704
  2. Hazardous Materials Emergency Response Guidebook, U.S. Department of Transportation. Washington, D.C. 2008. http://www.fmcsa.dot.gov/safety-security/ hazmat/2004-emergency-response-guidebook.htm