Require Grounded Plugs on All Electrical Equipment

The National Safety Council reports that about 1000 people are electrocuted each year in the United States. That means grounded plugs on all electrical equipment in the lab are very important.

By James A. Kaufman

Require Grounded Plugs on All Electrical Equipment and Install Ground Fault Interrupters (Gfi’s) Where Appropriate

The National Safety Council reports that about 1000 people are electrocuted each year in the United States. In 2005, a biology professor at Cleveland State University died as the result of an electrical shock in the lab.

OSHA specifies that all equipment in the workplace be grounded to avoid shock and possible electrocution. Removing or breaking off the ground pin is a bad and potentially fatal idea.

Most people are not aware of the danger associated with ungrounded equipment. This danger is compounded when the plug is a two-prong unpolarized type. If inserted backwards, the case of the appliance can be electrically hot. We find many in labs that are 50 to 120 volts hot.

This same problem can be caused by two other circumstances: (1) the electrician wires the receptacle backwards or (2) the appliance manufacturer does not follow the convention. In any of these three cases, if one is near a ground, serious or fatal shocks can occur. Make sure that the ripple side of the appliance cord is connected to the wider side of the receptacle.

A ground monitor or circuit analyzer can be used to ensure that the receptacle is correctly wired. An AC-sensor can tell you if the case of the appliance or device is electrically hot or not. A Tension Tester will indicate if the receptacle is holding on to the plug’s prongs with sufficient force to meet electrical code specifications. All three tests should be performed annually on receptacles and electrical equipment in the lab.

The use of Ground Fault Interrupters (GFI’s) can provide significant shock protection. They should be installed in any location where the receptacle is within six feet of a ground or water is likely to be present on the floor or surfaces.

Published In

Changing Spaces Magazine Issue Cover
Changing Spaces

Published: December 1, 2011

Cover Story

Changing Spaces

Over the last decade, traditional office and R&D designs have failed to serve new business models and employment arrangements; the results have been visible at the bottom line of balance sheets. The real bottom line is this: Better workplaces make for better business.
We have updated our Privacy Policy to make it clearer how we use your personal data.
Please read our Cookie Policy to learn how we use cookies to provide you with a better experience.